← Back to The HUT

August 1970 · Volume/issue not printed or unknown

August 1970 Magazine

Issue first-page cover

Magazine · 32 pages

August 1970 Magazine

Captured text — scan page 19

Automatically captured text may contain recognition errors. Compare it with the original scan.

On The 3MCC

The 3 M Canoe Club was formally organized on October 23, 1967,
and received status as achapter of the MCA shortly after that. The
initial organizing committee consisted of Al Buchholz, Al Button,
Curt Nordum, and Barry Tungseth. The cluh has grown from just a few
to over 50 members. Membership inthe 3 M Canoe Club is open to any
3 M employee interested in canoeing and the only dues required are
for membership. The club meets onthe second Wednesday of the month
at 5:00 or 7:30 p.m. Generally, the activities are similar to those
of the MCA with particular emphasis on building of both molded all-
glass and glass-covered strip canoes. The clubis jointly sponsored
by 3 M Company and the MCA, and, as such, has service to canoeing
and 3 M employees as its main charter. To this end, a one-piece mold
of the 17-foot Guide Model Canoe was made in the summer of 1968; to
date nearly 100 canoes have been made from this mold. Other molds
are in planning stages.

3 M Canoe Club members have longbeen promoting canoeing and con-
servation on a state-wide level. They helped publicize support for
the Wild and Scenic Rivers Act of 1968 before its passage and are
active in the BWCA mining controversy. Examples of 3 M Canoe Club
activity in the MCA include office holders and committeemen as well
as many people working quietly in less exposed assignments. Two of
them were instrumental in enlarging the MCA Building Booklet and acted
as liaison between the Minnesota Department of Conservation and the
MCA in preparation of the Department's "Minnesota Voyageur Trails".

A one-piece mold of the 17-foot Guide Model Canoe is available
for use by MCA members. Made in1968 by the 3 M Canoe Club, themold
has ends which open for easy removal of molded hulls and comes with
a complete set of instructions. A package consisting of the materi-
als necessary tomake a light weight, strong canoe, mold rental fee,
and air conditioned/heated trailer is available to MCA members for
$93.75 (polyester boats). The trailer, located on the east side of
St. Paul, is easily reached from Interstate 94 or Highway 36. Ca-
noes made from this mold have generally been lightweight (hulls av-
erage 50 lbs.) andvery strong when the directions have been followed.
Nearly 100 boats have been made from this mold and have stood up
very well. Generally, hulls are made inone weekend; the total time
depends on how fancy you wish to finish it. The mold is waxed and
ready to use when you receive the kit and keys to the trailer. The
average time required for 2-3 inexperienced people to make ahull is
below:

Apply mold release to mold and let dry. 1/2 HY.
Lay 1 layer cloth, glss microspheres
(optional) roving. 4-5 hrs.

Let cure, preferably overnight.
Lay last layer of cloth. Let cure one

full day. 1 hr.
Pop boat from mold, clean boat and mold. 1, AY.
Trim gunwale line. 1-2 hrs.
Install gunwales, seats, etc. Depends on
individual

13

Article contents & approved summaries (0)

No article summaries are available for this view.