April 1969 · Vol. 3 No. 6
April 1969 Magazine (Vol. 3 No. 6)
Magazine · 24 pages
Search this issue
April 1969 Magazine (Vol. 3 No. 6)
Captured text — scan page 15
Automatically captured text may contain recognition errors. Compare it with the original scan.
@ NEVER CRY WOLF by Farley Mowat, Dell Publishing Co.,
Inc. New York, paperback, $.50, 175 pages.
Here it is! Really a topical piece of science and
literature dealing with that all-—to-often-taled-
about subject, the WOLF. In a most humorous easy-to-
read slightly scientific style of narrative is the
experience one man faced while sitting a year outside
a wolf den. The satire of our bureaucratic world
trying to comprehend the wild tales of woe that travel
into those honored places of government is more than
one can imagine. If you put this book down it is for
some reason other than interest, for your eyes will
be glued to it until you're done. Tha author spends
time with a family of wolves in the Canadian wilder-
ness and comes up with some very commonsense obser-—
vations that will in time be more commonsense to us,
hopefully! Due to the cries of the natives, much like
we hear in Minnesota (7,000 wolves!!!), the Canadian
government decides to send old Farley, fresh out of
school, into the boonies to see about all the turmoil.
Expecting to be eaten alive, he instead finds a
sparse population, yet observes firsthand the day-to-
day activities of the wolf. No matter where you fall
on the issue of bounties, you can't speak effectively
until you have read this book. For half a buck, how
can you miss? KHRKK
™ ORACLE
Q. I recently coated my strip boat using epoxy. It
still seems to be sticky. Did I mix the epoxy
wrong or what?
A. Epoxy is quite difficult to mix wrong and will
set even though mixed in slightly incorrect pro-
portions, However, this material requires a few
days to set hard enough to sand; a week may be
necessary (at 60°F or lower). Any thermoset mat-—
erial sets even slower in thin coats, The cur-
rently recommended procedure is to use a roller
to wet the front half of the boat and then work
the cloth into the wet epoxy. Use a squeegee or
soft piece of plastic to smooth out the glass and
remove the excess resin. Repeat on the rear half
of the boat. After 12 to 24 hours, coat again
with resin then allow to set hard and sand, The
epoxy may feel greasy; this is a normal effect
with epoxy. Apply a final smooth coat and you
should be all set,
ale
Article contents & approved summaries (0)
No article summaries are available for this view.