← Back to The HUT

March 1985 · Vol. 21 No. 3

March 1985 Magazine (Vol. 21 No. 3)

Issue first-page cover

Magazine · 40 pages

March 1985 Magazine (Vol. 21 No. 3)

Captured text — scan page 29

Automatically captured text may contain recognition errors. Compare it with the original scan.

For example, what do you do when the MCA forms don't match the old
hull? Later I was to hear a perfectly plausible explanation from MCA
builder Bob Brown on why this was. The original builder had let the hull
spread out between fiberglassing the outside and the inside. That makes
sense now, but at the time it was a setback to discover that MCA templates
did not fit my canoe. (Using a method of my own invention, which involved
temporary cardboard templates and 3M Post-it-Notes, I managed to devise
new forms that matched the old hull.)

The real nightmare, however, was laying new strips around the sharp
side curves and trying to keep them from bulging too much between forms.
The MCA building book warns about this problem, but the solution it
suggests does not easily apply to rebuilding. When stripping up an entire
boat, you can taper the ends of the strips to reduce the bulge. When fitting
new strips into existing spaces, butt-to-butt against old strips, you can't.

During my protracted battle of the bulges, I was thankful for one
thing—that Blanehe knew less about canoe building than I and therefore was
foreed to confine her comments to the general rather than leveling specific
criticisms at my boat-building prowess. Her favorite remark during this
stage was, "Lake's gonna be froze over before you get that boat done." This
was in May. Occasionally she would venture into the garage, run a fingernail
over a few of the 1200-odd staples that held the whole unlikely contrivance
together and say, "With all this hardware in it, it'll sink for sure."

My reconstructed MCA Guide wouldn't have taken any prizes at last
week's canoe builders show, but it does float. It has survived its new life
maiden voyage to the BWCAW, where it carried more gear than any two
people should sensibly try to portage.

Now that the job is over, I don't know which was the bigger thrill—
seeing that canoe II didn't sink the first time I launched it, or being able to
say to the first person who asked if I built it, "Well, most of it."

Without a question, though, one of the most rewarding moments came
the day I got the drop on Blanche. The final stripping, staple pulling and
sanding had been done over the course of several nights so she hadn't seen
the transformation from work-in-progress to all-but-fiberglassed canoe. On
the Saturday morning late in June, when the weather seemed right for that
final event, Blanche poked her head over the trash can and just watched for
a full half-minute without saying anything.

"It'll probably never float, Blanche," I said.

"Oh it'll float," she said, nodding, then added, "Good fishing is almost
over for the season though." — David Stamps ,

(Editor's Note: Not all builders are master builders like the ones you saw at
last week's builders' show. Everyone has to start somewhere.)

The Crow Wing and its main tributaries is extremely clear, has little color,
and is not turbid, the result of good groundwater sources, sandy soils, and
lack of floods.

Streams and Rivers of Minnesota —
Tom Waters.

HUT! 29

Article contents & approved summaries (0)

No article summaries are available for this view.