← Back to The HUT

January 1987 · Vol. 23 No. 1

January 1987 Magazine (Vol. 23 No. 1)

Issue first-page cover

Magazine · 36 pages

January 1987 Magazine (Vol. 23 No. 1)

Captured text — scan page 13

Automatically captured text may contain recognition errors. Compare it with the original scan.

A "Kunz Gunnel" for a solo canoe can be built of Mahogany
(Phillipine) or Fir 1/2 x 3/4 inches. On a tandem, increase this to
5/8 x 3/4 inches. This should be all the wood you need. Should you
use a denser wood like Ash or Honduras Mahogany, the sizes can be
reduced by 1/8" on the smaller dimension.

Pine, redwood, or cedar are really too soft for gunnels.

In order to install a "Kunz Gunnell", you must plan ahead. Where
should the seat go? How about the thwarts? How many thwarts? How
long are the decks to be and of what type? Get all these things
clear in your mind before you cut any wood.

Spaces
k een ie
d lon Stru dec. a a = — 7

mN . 5
pacers r ig &

‘over laps

Fig 2 shows a “Kunz Gunnel" on a solo canoe. Notice the overlap
where the thwarts attach. You now have a 1 x 3/4 inch section of
wood to drill through. Bolt your thwarts to the bottom surface of
the overlaped area. Use 3/16" steel or 1/4" brass bolts with flat
washers, and the thwart will be very secure. I've seen screws, dowels
and all kinds of hardware used to hold the thwart flush with the top
of the gunnel. None are as strong.

On a typical solo canoe, the seat should be at gunnel height.
Again, bolt it to the bottom of the gunnel with a bolt in each
corner. Use spacers 1/2" to 3/4" on the forward edge only, to lower
this edge for comfort. Simple, solid and light.

Notice the spacers between the center gunnel section and the
inner skin of the hull. These spacers should be 3-4 inches long with
nearly equal spaces. The space on a solo canoe must match with the
seat placement. On a tandem canoe, they match the thwarts. This
creates the doubled area where you drill and bolt on parts.

I love long decks, but they add weight. Now I build long decks
of 1/4" strips and glass them in place. Simple, strong and light.
This deck also eliminates the need for fancy fitting of the end
parts.

Remember when you trim out your canoe, keep it simple and keep it
light. Save all that fancy woodwork for you living room furniture.

Old dogs can learn new tricks. My "Tern" was going to be a real
show-stopper. When the stripping was done and the surforming well
underway, I realized that I had too many large cracks to fill.

I had tried the Kunz method of mixing sawdust and glue with
limited success. There had to be a better way.

I tried something that is working so well that I am still amazed.
I mix sawdust and glue all right, but I do the mixing right in the
crack.

BUILDERS CORNER - CONTINUED ON PAGE 14
HUT! 13

Article contents & approved summaries (0)

No article summaries are available for this view.