← Back to The HUT

November 1987 · Vol. 23 No. 11

November 1987 Magazine (Vol. 23 No. 11)

Issue first-page cover

Magazine · 32 pages

November 1987 Magazine (Vol. 23 No. 11)

Captured text — scan page 14

Automatically captured text may contain recognition errors. Compare it with the original scan.

BUILDERS CORNER--FAIRING UP THE FORMS

I draw a complete blank from some builders when I mention
fairing. Some omit this step completely, and the result is often a
misshapen boat. No amount of glitzy inlay or shiny varnish can make
a misshapen canoe look good in my mind,

The importance of fairing is inversely proportional to the
distance between forms, Boy that was a mouthfull, I ought to be
selling canoes, not building them. Seriously, on a boat with widely
spaced forms, like the Guide, fairing is not terribly important .
The forms are so far apart that a natural shaping of the strips
simply happens.

Why then would a designer put in more forms? Why have them
closer together when a-natural shape will happen with less? No two
Guides are the same. Very simply, their shapes vary from boat to
boat.

As the designer brings the forms closer to get better control of
of the shape, fairing becomes more and more important. A slight
error becomes more evident.

On my recent designs, the spacing is either 12" or 30 cm., with
this spacing you can maintain better contro] of the shape.

The most common errors in set-up result in either a tight bend
near the first form, or a wavy keel line. These errors show up on
the finished hul] and need not have happened. Fairing only takes a
few minutes and is a perfect time to detect any errors in your
set-up.

Fairing is a job best done with a helper. You and your helper
simply take a straight strip and lay it lengthwise anywhere on the
hull. The strip should touch all forms and end pieces at the same -
time. You may need a slight endward pull on the strip to make it
pull into place. Repeat this check every few inches around the hull,
do both sides.

If your hull] checks out and you find no tight bends anywhere,
consider yourself Jucky and start stripping in complete confidence.

More often, you will find that the strip missed somewhere in its
length, often near the ends. This is a sign that something is amiss.

When you find an error, check the other side. Is the boat
symetrical? You may simply have a form off center. If the error
proves to be symetrical, you then know that you either have a
misshapen form or one in the wrong position.

The easiest change to try is to move the suspicious form endways
or moving the end piece. A small change here can often correct the
problem.

Any suspicious forms should be checked against the original plan.
You may have made an error in transferring the shape from plan to
form.

When nothing else works, consider reshaping the form in question.
I do this commonly with my new designs, but you shouldn't have to on
a proven plan. When I do change the shape of a form, I do it a
Jittle at a time with a disk sander, taking the same amount off
either side.

On a symetrical hull, any error should show up in both ends.
Whatever fixed one end should be good for the other.

Check the keel line carefully, nothing shows poor workmanship
quicker than a 1/4" dish in the keel line, I've seen this far too
often. The error overshadows al] the nice things that you see. You
may wish to shim up the low forms to get a fair keel line.

Check again the line where the sides flow into the end, alJ too
often there is a tight bend near the first form. Don't be timid
about adjusting the position of the end piece. (Unless it’s a racing
canoe.) A slight adjustment in length can often solve a problem in

14 HUT!-November 1987

Article contents & approved summaries (0)

No article summaries are available for this view.