February 1988 · Vol. 24 No. 2
February 1988 Magazine (Vol. 24 No. 2)
Magazine · 36 pages
Search this issue
February 1988 Magazine (Vol. 24 No. 2)
Captured text — scan page 13
Automatically captured text may contain recognition errors. Compare it with the original scan.
TIPS: Here's an interesting tip, learned from Dick Windberger: Once
a year or so, pour a capful (no more!) of "“Gum-Out" carburetor
cleaner into your gasoline-filled stove. Run the stove dry. The
Gum-Out will dissolve built-up varnishes and restore the stove to
good working order.
Here are some other stove maintenance tips! 1) Never leave fuel
in your stove over the winter. Run your stove dry at season's end.
Gas left in fuel tanks will cause varnish build-up, which clogs the
check-valve and jet.
2) Best bet is to burn Coleman or Blazo fuel, rather than
commercial "white gas" (hard to find these days.) Commercial stove
fuels are actually Naptha, not gasoline, and naptha burns more
efficiently in stoves than white gas.
3) Never burn automotive lead-free gas or standard leaded gas in
a stove designed for "white gas only." Automotive fuels contain
additives which may be harmful to trail stoves.
4) Lubricate your leather pump washer sparingly with a good
grade of oil (I prefer quality gun oil). Stoves run very hot, and
Jow temperature oils may hreak down and clog the check-valve.
Vegetable o{1, according to Dick, is a real disaster!
5) Don't fill your stove more than three-fourths full. It won't
generate pressure. Some stoves (like the Old Coleman Peak 1's) would
erupt into a ball of flame if over-filted!
6) Check the temperature of the fuel tank by touching it with
your hana from time to tine. If it's too hot, the pressure is too
high. Remedy: Lower the flame and/or pour cold water on the tank.
You can blow a safety valve! Or worse, melt the solder around the
tank filler neck. I once watched an Optimus 111B erupt into a
flame-thrower when this happened. The user was frying fish in an
oversize pan. The stove was out-of-commission until its tank could
be silver-soldered.--Cliff Jacobson
IN DEFENSE OF THE PEAK I
Once again I must disagree with Cliff. I have owned a Peak 1
stove since 1981 and have not had any trouble with it.
Yes, Cliff, a Peak 1 will probably give you troubte if you
over-fill it. To that I say, "Hey, dummy, why don't you follow the
directions that came with your stove?" It says very clearly to fill
jit on a level surface and NOT to over-fill.
In the past, Cliff has disparaged the Peak 1 because of its
"knobs and wires that will eventually break and burn off." Hawgwash!
There isn't a piece of camping equipment made that will stand up
to neglect and abuse. I've always treated my Peak 1 with care and it
has never lost a part or caused me trouble. Early on I decided to
protect it from transport abuse. First I purchased the Offical
carrying bag. (Overpriced, but not totally out of reason.) Next
came a wonderful little two-quart pot that Mirrco made for only a
couple of years. The stove in its bag fits into the pot. Now I can
jam the whole works into a Duluth pack without fear of ending up with
bits and pieces floating off into never-never land.
A cheap way to protect your stove is with a 2-pound coffee can.
If you bend the throttle lever on the stove so that it hugs the tank,
it will slide into the can. (Use two pair of pliers to bend it and
be careful not to break the plastic knob.) You will have to push the
bottom of the can down to get the stove down far enough to get the
plastic lid on the can. Set the can on a hard surface and push (not
pound) with the end of a 2x4 to flatten the end of the can.
Dollar for dollar the Peak 1 is very hard to beat. Don't over
Fill it, make sure that everything is tight once in a while and
protect it from hard knocks and it is entirely adequate for 99% of
the camping public.~--James Robinson
February 1988-HUT! 13
Article contents & approved summaries (0)
No article summaries are available for this view.