← Back to The HUT

June 1988 · Vol. 24 No. 6

June 1988 Magazine (Vol. 24 No. 6)

Issue first-page cover

Magazine · 52 pages

For the full-resolution original, use Open PDF above. Your browser handles PDF zoom and navigation.

Scan page 10 of June 1988 Magazine (Vol. 24 No. 6)
Searchable text for scan page 10

CLIFF°S CORNER--GETTING A GRIP ON THINGS

Whenever I conduct a canoe seminar,
someone invarfably brings up the subject of
paddies. So, I first preach the basics--no
“nose to toes“ measurements to determine
length: Instead, there's the "scientific
approach," which takes into account the length
m of your torso, height of canoe seat and draft

of the hull. Ultimately, I top off with the
" variables which go into making a really fine
paddle,

As I look back on my preachings, I'm
amazed to discover that I almost always
overlook--or at best discount--the most
important factors in paddle selection; namely,
the feel and contour of the grip and shaft,
and the overall balance.

An upper grip that’s too small will tire
the hand, maybe even induce “carpal tunnel
syndrome." And a grip that's too large will
simply feel awkward. Most canoeists learn to adapt to the grip
supplied by the factory. Not me. If it’s not exactly right, it bugs
me. No amount of convincing will make the paddle suitable for my
purposes, even if all the other “paddle factors" are on target.

What then are you to do if you've found a nice paddle, but loathe
the grip? One solution is to keep shopping. Another, fs to buy the
paddle "Jong," lop off the grip and attach your own. A grip that's
too large (and very few are) can be shaved down. One that’s too
smal] is another niatter.

Shaft contour is another concern. Some of the older, large
“racing shafts" are too big for my hands, and I've not hesitated in
taking a wood rasp to them. Small shafts (technically called the
"loom") are impossible. They tire my lower hand. I usually sell or
trade paddles which fall into this category. Or I keep them around
as lJoaners.

A gently rounded shaft contour feels best to me, I dislike harsh
curves. Round shafts are the pits, and are generally the mark of an
inferior stick. There are lots of good paddles out there, and each
canoeist develops a personal preference. To date, I've never had a
commercially built paddle which felt exactly right as it came from
the’ maker. Everyone required some customizing on my part. Sticks
which have come close to complete perfection include my Hidde Classic
and Foam Core, and a solo freestyle paddle built to my specs by Clint
Waddell.

Finally, there is the matter of “tipping.” At this writing,
Bending Branches seems to have the edge with their ROCK GUARD tip.
I've nailed a number of rocks with my BB paddle, some to purposefully
test the strength of the material. Still no repairs required after a
full season of whitewater.

What about off-set grips on straight paddles? This seems to be a
national trend, not one I'm sure I like. Canting the grip does
wonders for “going straight," and is quite comfortable for general
canoeing. But it's out of place for whitewater work where you
absolutely must have positive control of the blade angle. Sure, you
can paddle rapids with a hooked grip... or a 14-degree bent shaft.
You can even use a shaved down two by four--none of which excel at
the job.

Lately, my paddle choices center around three models: A
14-degree 54-inch stick for slick cruising and general solo boat
paddling; a 56-inch straight shaft with T-grip for positive control

10 HUT!-June 1988

Article contents & approved summaries (0)

No article summaries are available for this view.