← Back to The HUT

October 1988 · Vol. 24 No. 10

October 1988 Magazine (Vol. 24 No. 10)

Issue first-page cover

Magazine · 44 pages

October 1988 Magazine (Vol. 24 No. 10)

Captured text — scan page 19

Automatically captured text may contain recognition errors. Compare it with the original scan.

in combination with other additives. Filleting blends are added ‘to
give epoxy thick, gap filling properties that can be used to
reinforce structural areas. Graphite powder can be mixed with epoxy
to create a very hard, slippery, abrasion resistant surface.
Collodial silica is often added to this mixture. I put it on
four-foot triangles of the bottom of the Peregrine to increase
abrasion resistance in these high wear areas, ala Martin Van. On the
canoe's test cruise we went over a rock that scraped an area with
graphite and an area without it. It left a barely perceptible
scratch on the graphite and.cut down to the cloth on the area without
it. Graphite seems to work.

A good way to apply these mixtures is to put on coats of straight
epoxy on the surface to be bonded and apply the mixture between them.

I used the slow-cure hardener for this canoe. A note to remember
is that the epoxy jis hard enough to sand after nine hours, but that
it continues to cure for 36-48 hours after that.
--Mike Ludvigsen, Building Director

WE SUPPLY THE EQUIPMENT... YOU SUPPLY THE ADVENTURE
Hwy. 100 at 36th Street 929-1351

Hoigaards

October 1988-HUT! 19

Article contents & approved summaries (0)

No article summaries are available for this view.