← Back to The HUT

September 1973 · Volume/issue not printed or unknown

September 1973 Magazine

Issue first-page cover

Magazine · 16 pages

September 1973 Magazine

Captured text — scan page 12

Automatically captured text may contain recognition errors. Compare it with the original scan.

Plane the blade area for flatness and to re-
move excess glue. Glue and clamp handle

BS $
Tips on eee ae ee
before glueing.
] B
Paddle Building

by
Bill McArthur

Fig. 6

[ .
Laminated canoe paddles are easy to blade is about 13” wide by 15” long or \

build and with the cost of buyinga good — even a 13” round blade would work well. af}
one, making them is an attractive alterna-

tive. Very few tools are needed. Latch on

to someone with a table saw, get yourself

a can of good waterproof glue, a little The handle can then be built up, glued
spruce, a hand plane, and some sanding and clamped.

gear (an electric drill with sander is fine);

and you're ready to begin.

I made an edge glueing jig for use on
my workbench, with which two threaded
rods with wing nuts soldered on the end ;
apply the pressure to the edge of the
wos i=nn

' Fig. 7
2«2 CLAMP TO Fig. 3
BENCH 2x4 SLIDES ON
NUT \ Several handle styles are also used and Now you're ready for shaping and sanding.
any of these can be put on any of the
— BENCH TOP styles shown.
rec
Fig. 1 A Ag
In general, I like to make handles at ee

least 1” wide, 1 1/8” is real good and
about 1 1/8” to 1 1/4” thick. Blades can
be 1/4” or even 3/16” thick if glassed on
both sides, but remember there will be B-B

Co
A-A
some loss due to planing after glueing. I
like Sitka Spruce best for most stock. .
Cedar is okay but splinters easily when Fig. 8
stripping. I use cedar, mahogany or wal-

nut for accent color strips.
There are many blade shapes which

people like and any can be made in any Fig. 4
of the ways described below. The most is fairly easy on this design due to the
popular blade is about 8” wide x 18” to ; oo, square or flat edge. Use — strips or
24" long. The easiest method which gives a good strands of glass — unravelled roving or
paddle is as follows: Cut strips 1/4” thick ‘cloth does well. Wet the edge of the blade
and edge laminate, handle and blade. with resin and start to lay strands on the
1/4” edge. Saturate the strands as added.
After the first few strands, put a piece of
oversized wax paper on each side of the
blade to form a channel into which to lay
=a the strands. Continue building up until
Me ih 7 there is 1/8 - 1/4” of glass over the end
oA and corners of the blade and feather off

f up the sides as shown.

Next, I like to add fiberglass support
to the bottom edge and corners so the
paddle is not damaged on rocks. This step

Fig. 5

Fig. 2 I

I have made a banjo which I enjoy F
very much in shallow rocky streams. Its LA

10 HUT! SEPTEMBER 1973

Article contents & approved summaries (0)

No article summaries are available for this view.