← Back to The HUT

December 1976 · Volume/issue not printed or unknown

December 1976 Magazine

Issue first-page cover

Magazine · 20 pages

For the full-resolution original, use Open PDF above. Your browser handles PDF zoom and navigation.

Scan page 5 of December 1976 Magazine
Searchable text for scan page 5

The sailing canoe

By Bob Brown

432-7557

The lee boards are normally mounted on the end of a
temporary thwart that is clamped to the gunnels of the boat.
This makes the boards easily removed. It also allows their
position to be adjusted, a real aid in trimming the boat.

I would like to discourage anyone not familiar with
sailmaking from trying to sew their own. My first two sails
were homemade cotton sails and both were very marginal.

The most common sail cloth used today is dacron. It is
nearly impervious to air and water, it stretches very little
and costs a few dollars. Plan on spending some money for
your sail, this is your motor so get a good one.

The spars can be made of wood, but I prefer aluminum
tubeing of a 6016 hardness. Again this costs some.

\— Rurdler
SJeeriag Arm
—Sfeering tines

leeboard Thwart

Any boat can be made to sail. A canoe does it quite well.

A canoe sailing rig can be built by anyone with a little
skill. A modest cost can add a new facet to your canoeing
experience.

The rig described here will not interfere with the
normal use of the canoe as most of it is removed when not in
use.

The two most common rigs used for canoes are the
lateen and sliding gunter rigs pictured. Both types are good.
The sliding gunter rig is the more efficient of the two .

On either rig I suggest that the mast step be secured
permanently at the forward thwart. The rudder hinge
should also be mounted permanently to the stern.

Anyone interested in building a sailing rig is invited to
join our new sailing chapter. Hopefully when we get this
group started we can combine our experience and come up
with some good sailors.

Anyone desiring to go it alone, I'd like to advise making
the lee boards of no less than %” lumber. Plywood doesn’t
make it. A section of 1X10 lumber with a little shaping
makes a fine set of boards. This same material is also
suitable for the rudder.

Sliding Gaiter Rig

ae

| Geez

T

At present there are several small sail boats on the
market that have a small lateen sail. A “Snark” is one of
them. The Snark has a sail just about the right size for the

beginning sailor.

One might find a dealer who will sell for a reasonable
price the spars, mast and sails for a Snark. You might also
find one of these boats badly busted up and be able to buy
the rigging from the former owner.

I have drawn a lateen rigged canoe and named the
parts. Basically this is what most sailing canoes look like.

Get busy. Spring is right around the corner. Building a

sailing rig will make the winter pass more quickly. I hope to
hear from anyone interested in sailing.

Page 3

Article contents & approved summaries (0)

No article summaries are available for this view.