April 1977 · Volume/issue not printed or unknown
April 1977 Magazine
Magazine · 20 pages
Search this issue
April 1977 Magazine
Captured text — scan page 16
Automatically captured text may contain recognition errors. Compare it with the original scan.
Plane the blade area for flatness and to re-
move excess glue. Glue and clamp handle
a
Tips on pe Bape leo ee
before glueing.
i] BS
Paddle Building
by
Bill McArthur
Fig. 6
[ :
Laminated canoe paddles are easy to blade is about 13” wide by 15” long or \ |
build and with the cost of buyinga good — even a 13” round blade would work well.
one, making them is an attractive alterna- =f
tive. Very few tools are needed. Latch on
to someone with a table saw, get yourself
a can of good waterproof glue. a little The handle can then be built up, glued
spruce, a hand plane, and some sanding and clamped.
gear (an electric drill with sander is fine),
and you’re ready to begin.
I made an edge glueing jig for use on
my workbench, with which two threaded i li
rods with wing nuts soldered on the end
apply the pressure to the edge of the
weet i—a8
Fig. 3
Fig. 7
242 CLAMP TO
BENCH 224 SLIDES ON
\ BENCH
ale Several handle styles are also used and Now you're ready for shaping and sanding.
| any of these can be put on any of the
styles shown.
: r x rec
~" tote Cf)
Ge N\__]
l>
In general, I like to make handles at
least 1” wide, 1 1/8” is real good and
about | 1/8” to 1 1/4” thick. Blades can
be 1/4” or even 3/16” thick if glassed on O Saas
both sides, but remember there will be B-B &«
Ce
A-A
some loss due to planing after glueing. I
like Sitka Spruce best for most stock. .
Cedar is okay but splinters easily when “a8
. Stripping. I use cedar, mahogany or wal-
nut for accent color strips.
There are many blade shapes which
people like and any can be made in any Fig. 4
of the ways described below. The most is fairly easy on this design due to the
ae blade is about 8” wide x 18” to oo, square or flat edge. Use eee strips or
24” long. The easiest method which gives a good strands of glass — unravelled roving or
paddle is as follows: Cut strips 1/4” thick cloth does well. Wet the edge of the blade
and edge laminate, handle and blade. with resin and start to lay strands on the
1/4” edge. Saturate the strands as added.
After the first few strands, put a piece of
Fig. 5 oversized wax paper on each side of the
blade to form a channel into which to lay
L BENCH TOP
Next, I like to add fiberglass support
to the bottom edge and corners so the
paddle is not damaged on rocks. This step
wi
$ the strands. Continue building up until
Tee there is 1/8 - 1/4” of glass over the end
oA and corners of the blade and feather off
f up the sides as shown.
c :
I have made a banjo which I enjoy f
very much in shallow rocky streams. Its LA
Article contents & approved summaries (0)
No article summaries are available for this view.