October 1981 · Volume/issue not printed or unknown
October 1981 Magazine
Magazine · 12 pages
Search this issue
For the full-resolution original, use Open PDF above. Your browser handles PDF zoom and navigation.
Searchable text for scan page 7
Builders Corner ; Use a piece of roving i to 1-1/2 inches shorter than
strips of fiberglass cloth. (Two or three bundles are
recommended for heavy paddle use.) Using rubber or
plastic gloves, dip one end into the resin, then the
ONE WAY TO FIBERGLASS: other. Lay soaked-out roving on top of cloth stack.
A CANOE PADDLE Gently lift stack by ends and flip over the end of the
paddle lengthwise. Fan corner crease until it
by Al Button disappears. Make sure roving stays on tip of paddle.
Keep working, if necessary, to remove bubbles and
Fiberglassing a canoe paddle blade increases its life. creases for half an hour or longer, until resin gets
A paddle thus processed is less likely to chip or tacky. However, as soon as possible, turn paddle
erack, and the protection is a must in serious blade downward to keep resin at tip and avoid
whitewater paddling. further dripping, continuing to work strip.
Materials required are: Paddle, sandpaper or varnish Note that only roving strands are used, not the roving
remover, newspapers or plastic drop cloth, scraps of itself. The roving strands prevent the resin from
4-oz. or 6- or 7-oz. fiberglass cloth, scissors, paper chipping and cracking as unreinforced resin would do
cup, small amount of epoxy resin, waxed paper, 1- to under brutal pounding.
2-inech brush, one to three pieces (bundles) of roving
(18 1/2-oz.), rubber or plastic gloves, rag, and acetone _ Have a rag ready to wipe off drips. Use acetone to
cleaner. clean brushes when finished.
Assemble your materials. Apply sandpaper or varnish
remover to the bottom two inches of the paddle ke sx sr
blade. Tape the paddle, blade upward, to a table leg
or other similar structure. Protect floor and table
with newspapers or plastic. Bias cut two pieces of
the 6- or. 7-oz. fabric 1-1/2 inches wide by 9-10
inches long (one inch longer than paddle width—an
8-inch blade requires a 9-inch length of fabric). Trim
eorners or round ends of cloth. Bias cut two pieces
of. 4-oz. cloth similarly, except make them two inches
wide.
ANOTHER WAY TO FIBERGLASS A PADDLE
by Karl Ketter.
Remove old finish from paddle with sandpaper.
Fill cracks, splits, or gouges with thickened polyester
3 . ‘ fi resin or epoxy—whichever is more convenient.
Mix a small amount of epoxy resin, about one inch in at OP Sry PAREN
the bottom of a paper cup. (The finish of epoxy is
tougher and harder than alternate products, and it is
easier to work with because it's gluey.)
Fix blade into a horizontal position. Lay on a full
layer or strips of 4-oz. fiberglass across the blade.
Apply polyester resin. Do not attempt to fold cloth
around edges, but wet cloth to and slightly beyond
Lay a 4-oz. strip on waxed paper. Use brush to wet cnani, ‘Tye ceain. wake
strip with resin. Stack on second 4-oz. strip and wet
down. Add the 6- or 7-oz. strips one at a time,
wetting each with resin. Stretch each strip
lengthwise as you lay it down (the bias cutting
permits maximum stretchability).
Turn paddle over and repeat on other side of blade.
Let resin set.
Trim the glass that extends past the blade edges with
metal snips, coarse sandpaper, or coarse metal file.
Sand surface of blade to remove runs.
Apply second layer. of resin to fill cloth weaves and
the gap that appears at the edges between the two
layers of cloth. Option: Place a graphite fiber or
two into the groove around the edge of the blade. If
using graphite, also use epoxy for this groove.
INSIDE |NEXT TO PADDLE TIP
LAY ACcKosS TiP PUSH CPGES GF —— 2-3 ROVING STRANOS === SEES
CLOTH DOWN ee So
STRETCH - ONTO PADDLE
: FACE wiTH . ° . ;
FINGERS STRETCH QS SRNR on RCE TES SURO RET. STRETCH
WRINKLES ———_,
7 oz Bias CUT 19x" —_—
ps STRETCHED 12.
ye
SEINE Fy
wt
fil
al a
SOM taper oy SA
eels NE
Kop
| , | STREICH f-
\ fy a rn
PUSH OUT CORNER WORK OUT AMY
WRINKLES AS BULSLES . “
SHOWN bY ee
ARROWS FINISHED W035 GUT SIOE
LOOKS CCE THIS
Article contents & approved summaries (0)
No article summaries are available for this view.