June 1984 · Vol. 20 No. 6
June 1984 Magazine (Vol. 20 No. 6)
Magazine · 16 pages
Search this issue
June 1984 Magazine (Vol. 20 No. 6)
Captured text — scan page 10
Automatically captured text may contain recognition errors. Compare it with the original scan.
\ THINGS THAT GO WRONG
Cooke Custom Seusing
Cordura Nylon Canoe Packs aE Es
twill be empressed by our blend - Bob Brown, Building Director
tradittonal innovati
"ides hich (ode taryerttory As building director for the MCA, I get
over a decade of experience many calls regarding problems that arise
in the BUCA. while building. The majority of the
(Check out these features: problems are in the glassing operation so
I thoy Cordura- waterproofed hot cat I'l] start with those problems.
+ 100% nylon thread and webbing Many problems arise because the builder
BPR. aster quica-release buckles doesn't understand the difference between
Padded shaulder strap - haul Loop wax and no-wax resin. Either type of
ABA || {weoding reinforced stress points polyester can be used for canoe building.
jot impressed uct ? Each has its advantages and drawbacks.
. cheek out You must know what you are working with.
our prices Ploly resin doesn't cure in the
and our presence of air. The outer surface will
1 Cr9flLomanship. stay sticky unless the air is sealed off
Me vaitad . from it. Many ways have been developed to
: ‘al ME [all (ie do this such as covering the surface with
Ser eerie : = — saran wrap or wax.
comet ek : “sr as “55° A very small amount of Parafin Wax can
a3 5Q7 24 | Ele Fanny pack 477 be added to the resin. This wax will
- . float to the surface of the curing resin
Contact Dan or Karen Cooke 184 S117 and seal off the air. Resin can be
obtained with this wax already in it or
you can add it in yourself. I prefer to
add it in to the last coat only.
Okay a few problems! You bought your
resin, the no-wax type; you didn't get the
wax to go with it; and you've been told to
just add some floor wax.
Take a look at the ingredients of the
floor wax. Most of them have either water
or petroleum distillate as a vehicle.
What would you expect to happen if you add
water to your resin? That's right folks,
SEE THE BEAUTY. anything from a complete failure to sticky
FEEL THE LIGHTNESS. surfaces or a milky finish.
DON'T add floor wax; no matter who
tells you.
IMAG ! NE THE FU N. A different guy called. He used waxed
resin. A couple days after glassing there
Take our tip... are still sticky spots on the hull. After
a lengthy discussion it was learned that
he hadn't shaken the resin.
buy Bending Branches quality.
For more information write: ; Wax floats to the top of the resin. If
BENDING BRANCHES PADDLES you mix several small batches, like
eee eg ee SS Favs, MIG Ba recommended, the first few batches get all
the wax and the last get almost none. If
OR CONTACT THESE FINE DEALERS: you use waxed resin shake it up thoroughly
e EASTERN MOUNTAIN SPORTS BOAT BUILDERS - then shake it some more.
+ PERS) Re Lhie Boke aa Occasionally a batch of resin refuses
eee a ee oon Srone > West System Epoxy} to set at all. This differs from the
sERHIG BAUER — Strips sticky surface found with the no-wax.
°SKI HUT —. When resin won't cure its usually because
° REI ~ Sakee of not enough catalyst added to the mix.
:0 HUT!
Article contents & approved summaries (0)
No article summaries are available for this view.