← Back to The HUT

November 1984 · Vol. 20 No. 11

November 1984 Magazine (Vol. 20 No. 11)

Issue first-page cover

Magazine · 12 pages

For the full-resolution original, use Open PDF above. Your browser handles PDF zoom and navigation.

Scan page 5 of November 1984 Magazine (Vol. 20 No. 11)
Searchable text for scan page 5

THE KUNZ GUNNEL

: —
Bob Brown, Building Director Pal S
Ever had problems finding gunnel stock ~ _
long enough for your canoe. Bruce Kunz Lape a
did! ...and he figured out a great | ‘oe W
solution. ra Loy
On his first "Merlin" Bruce decided to Y
build up the gunnels from short Y)
overlapping pieces of mahogany. He
started with a piece of inahogany on either N A O!
end that ran past the place where the = Li] &
thwarts were to be installed. A center VY Wipes LL ~— <
section was then added that overlapped =
either end piece by about a foot. Spacer Li z;
blocks were added to keep this section a ila U) ny
parallel to the hull. is tae

A little experimenting with the spacers a ©
and he ended up with a solid section where on
the seat was mounted and a very attractive
ventilated gunnel. fam

Many builders ‘overkill' on the gunnels Ss

because they want plenty of material to

bolt in thwarts, seats, etc. The Kunz ica !
gunnel eliminates the problem of fastening ,
to a skinny rail because it is doubled |
everywhere that fastenings are done. : '

I saw how well the system worked and ’ =)
used it on my “Free Spirit". Beautiful '

results. Free Spirit is a very full boat
with flat sides and all the curve near the
ends. I maintained tnis shape very easily
by using slightly thinner end sections and

thick in the center. —
Many modern canoes don't have a fair =

curve on the gunnel shape. They are

designed with varying amounts of curve. _ |

If a builder goes ‘overkill’ on the = roa eee

gunnel, he forces the hull to take a > “4

faircurve. He has now blown the best

intentions of the designer. a a

Keep the gunnels thin -- 1/4 inch rub

rail on the outside, 1/2"X 3/4" inside.

Thats all folks!!; anymore is overkill.

Use a Kunz gunnel and you have 3/4"X 1" pitts
stock to bolt your thwarts to.

I've seen overkill on thwarts also. 7 |
Too often {'ve seen 1"X 2" ash thwarts
installed with screws tnru the hull into
the endgrain. Someone is kidding
themselves.

Bolt in your thwarts, Dolt them to the
bottom side of the gunnels. Its so simple
that I wonder why we ever did it any other
way.

Keep it simple and keep it light. The :
Kunz gunnel lets you do both. It looks ‘ :
good too!

HUT! 5,

Article contents & approved summaries (0)

No article summaries are available for this view.