August 1978 · Volume/issue not printed or unknown
August 1978 Magazine
Magazine · 12 pages
Search this issue
For the full-resolution original, use Open PDF above. Your browser handles PDF zoom and navigation.
Searchable text for scan page 7
7) If you’ve made it this far, you'll
realize they’re easier to build and use
than to describe. To load things up:
a) Slip the fixed loop of a top line over
an eyebolt in the center of the 2x4 -
pulling towards the side away from the
f all the eyebolts
>y form somewhat
near the center (I
a radio antennae
on’t use a radio
iminum canoe on LINES opening in the eye—and throw it over the
cked the SWR as - FOR top of the canoe. Make 2 turns around
lio ) of each 2x4 SECOND SHORT the end of the 2x4 and tie a choker
g each side of the CANOF LINE around the main line about 8—10 inches
ut and flat washer up from the 2x4. Once these loops are
- = tied and adjusted, don’t untie the knots
| : i if mm) to remove the canoe. Just slide the cho-
s, shift until they ker all the way down then use that slack
ther at the widest LONG LtA/E
: to slip the two turns off the end of the
’s to length - leave F :
2x4. b) Slip the front and rear lines
st the bracket or
‘tra length on the F/G, 3 FRONT OR. REAR yew over the eyebolts on the bumpers and
sabe art The GRE: snap the other end onto the eyebolt on
ental. Rand Bit OF . the canoe. Tighten by sliding the cho-
nee beeen -¥ou ker down the line and that’s it. If you’re
: here Hines see thas really cramped for trunk space, tie the
paddles to the thwarts inside the canoe
with elastic shock cord, and put life
. or rubber on the jackets etc. in a duffle bag and tie that up
4’s, either the full inside. Carry extra line for tying on an-
- 15 in. long where other canoe on the other side.
protects the canoe woop 8) Removing the eyebolts in the
it grips the canoe center of the 2x4’s makes them into good
moving around in EYE plywood, lumber or paneling carriers.
varnish the 2x4’s. For the ski season make two shorter top
olts, I painted the { RuBBER bars of wood and foam rubber, with an
(front bar-yellow, b SAMOE aii eyebolt sticking out one end. This hooks
it easier to install Ysa ie onto the center bolts and clamps the
so, small padlocks pf EZ} ZZ, = skis (3 pairs of touring skis per side)
am-lock tightening L | L a tightly down to the 2x4. See Fig. 4.
‘s and make the SKIS Fasten the outer end down with a hasp,
iL. Ts hard %6 axe draw latch, webbing or rope wrapped
riers are on the car around, etc.
lock locks the lever
lia Again, it is easier to make and use
rs forthe other 4 FIG. Lh. SMALL BAR. TO CARRY than to describe. It takes about 3 minutes
he ‘ to put the carriers on the car, load the
Ose tO end : Ss,
: : os Kil canoe, and tie it down. None of the
lines will prevent 7
ye. Don’t use exist- knots are tied or untied to load or adjust
robably for attach- the canoe. It’s easy to check and tighten
<, Use 2 hex nuts lines at gas stops, and the canoe is tight,
s on the 2x4’s) and even in gusty sidewinds. We hope it
oesn’t already have works for you as well as it has for us.
Sincerely
) the deck plate on ;
weit cies wash- Kevin & Jane Johansen
Relea 4125 W. 31st St.
Cut to length and
they don’t unravel.
on one end, and ei-
yp or an adjustable
ie other end. There
and one long line
the car. See Fig. 2
loop is made with
1, or whatever you
it under load but
hand. I painted the
ich lines to to front
color as the running
same color as the
St. Louis Park, MN 55416
>
Page 7
Article contents & approved summaries (0)
No article summaries are available for this view.