August 1984 · Vol. 20 No. 8
August 1984 Magazine (Vol. 20 No. 8)
Magazine · 16 pages
Search this issue
August 1984 Magazine (Vol. 20 No. 8)
Captured text — scan page 10
Automatically captured text may contain recognition errors. Compare it with the original scan.
CRUISIN’ ALONG a
- Jim Robinson, Cruising Director TT”
Any canoe trip depends on one thing: FIG. |
getting your equipment there. I have seen BOWLINE
many ways of tying a canoe on top of a
vehicle--some good, some bad, and some
downright dangerous. Some of the methods
of securing a canoe involve the use of
rubber rope or rubber tarp straps. Both
of these items are unsuitable because of
stretching when the canoe is shifted by
the wind. A further reason for not using
rubber tie-downs is that they are prone to
breakage if cut or nicked. I know that I
will hear from many people who have been
using rubber tie-downs for years, but I
still don't trust them,
The method I would like to show you is
not original, it is a variation of a meth-
od in "Wilderness Canoeing and Camping" by
Cliff Jacobsen. Other publications have
printed variations of this method. I will < S~hook
endeavor not to plagiarize too heavily
from Cliff in my description.
Start by obtaining 50 feet of 1/4-inch
braided: nylon rope. Make sure the nylon
rope you get is braided and not the
twisted type. Cotton or manila rope tend
to be hard to untie if wetted and allowed
to dry. Polypropylene rope is hard to tie rn
because of its slippery nature.
Cut the rope into 8 feet 4 inch lengths
and melt the ends with a match to prevent
fraying. You will also need six S-hooks.
The 1-1/2 inch size made of about 1/8-ineh
wire are the right size. It is better to Fi6é2
et hooks a little too large than too
sat, _ TRUCKERS
Close one loop of the hooks and tie a KNOT
hook to one end of each rope using a bow-
line knot as shown in Figure 1. DO NOT
TIE ANY OTHER TYPE OF LOOP. The bowline
is non-slip and can be easily untied,
‘other loop knots can slip or jam. The
hook end of the rope can be hooked to the
bumper of the vehicle. Tying the rope to
the bumper invites cuts by sharp edges.
Now for the other end of the rope.
Study figure 2. The trucker's knot must
be tied exactly as shown. It will not
work if tied incorrectly. Tie the knot in
a location that will permit pulling the
free end of the rope tight and secure with
a double half hitch as shown in Figure 3. wll
Tie up the loose end of the rope to i END
prevent whipping in the wind. ai
10 HUT!
Article contents & approved summaries (0)
No article summaries are available for this view.